Power Dynamics PRM606 User Manual

4
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
FRONT PANEL
1. Sd card slot
2. Mediaplayer display
3. Remote control sensor
4. USB Port
5. Media player buttons:
Mode - Press to change modes between playing SD, USB, MP3 and BT.
Play / pause - Press this button to start or pause play.
Folder - Press this button to enter FOLDER selection.
Repeat - Press the repeat button once to continually repeat ALL tracks, press repeat once more to repeat just the
current track.
Previous - Press this button to go to the previous track. Press and hold to scan backwards within tracks.
Next - Press this button to go to the next track. Press and hold to scan forwards within tracks.
6. Media playback zone assign buttons
7. Mic/Line 1 level control with zone assign buttons
8. Mic/Line 2 level control with zone assign buttons
9. Mic/Line 3 level control with zone assign buttons
10. Aux level control with zone assign buttons
11. Zone 1 output level control with monitor send button and level indicator
12. Zone 2 output level control with monitor send button and level indicator
13. Zone 3 output level control with monitor send button and level indicator
14. Zone 4 output level control with monitor send button and level indicator
15. Zone 5 output level control with monitor send button and level indicator
16. Zone 6 output level control with monitor send button and level indicator
17. Chime button with level control
18. Monitor headphones output with level control
19. Power on/off switch

Power Dynamics PRM606 Specifications

General

Maximum current	2 A
AC input voltage	220-240 V
AC input frequency	50 Hz
Amplifier class	D
Frequency range	100 - 24000 Hz
Output impedance	8 Ω
Peak power per channel	360 W
Signal-to-Noise Ratio (SNR)	- dB
Total Harmonic Distortion (THD)	- %
Purpose	-
Product color	Black
Rack capacity	2U
Connectivity technology	Wired
Speakers connectivity type	6.3 mm / RCA

Weight and Dimensions

Depth	390 mm
Width	483 mm
Height	95 mm
Weight	11850 g