20 GB/IE
3. Press the MODE button
4
. The appliance is
now ready for the second measurement.
4. Measure the next surface area.
5. Press the + / = button
12
. The message „+“
appears in the display.
6. Press the RM button
10
. The result of the first
measurement is shown in the lower row of the
display.
7. Press the + / = button again. Both measure-
ments are added and the result is shown in
the lower row of the display.
8. Repeat steps 2 to 7 to add further measure-
ments.
9. Press the MODE button
4
to leave the
addition mode. All the measurements will be
deleted.
Measuring volumes
1. Slide the function switch
9
to the position
„DISTANCE“. The display
2
is turned on.
2. Press the MODE button
4
twice. The message
„L“ (length) appears in the display.
3. Press the READ button
6
to measure the
length. The measured length appears in the
upper row of the display and the message
„W“ (width) starts to blink.
4. Press the READ button to measure the width.
The measured width appears in the upper
row of the display and the message „H“
(height) begins to blink.
To Next Page
Loading...
Need help?
General
