2
PM-30MV v3 2020-10 Copyright © 2020 Quality Machine Tools, LLC
PM-30MV
FAQ
220 Vac power connected?
Fuse good? (left side of this box)
E-Stop button out? (pop it out by
twisting rmly to the right.)
CHIP GUARD open? (close it)
R8 collets won’t go
into the spindle
The collet locating screw could
be in too far. Back it out a little.
My mill doesn’t run
This manual describes PM-30MV machines as shipped from June 2017. It contains essential safety
advice on the proper setup, operation, maintenance, and service of the machine. Failure to read, under-
stand and follow the manual may result in property damage or serious personal injury.
There are many alternative ways to install and use a mill. As the owner of the mill you are solely responsi-
ble for its proper installation and safe use. Consider the material contained in this manual to be advisory
only. Quality Machine Tools, LLC cannot be held liable for injury or property damage during installation or
use, or from negligence, improper training, machine modications or misuse.
There may be detail dierences between your specic machine and the
information given here (with little or no impact on functionality). Please
email us if you have questions about any aspect of the manual or your
machine (see our website www.precisionmatthews.com for support ad-
dresses). Your feedback is welcomed!
Copyright © July 2017 Quality Machine Tools, LLC
No portion of this manual may be reproduced or distributed in any
form without the written approval of Quality Machine Tools, LLC.
To Next Page
Loading...
Need help?
General
