Premax PM-CC35D User Manual

Hopper Plate Adjustment
When banknote feeding is unsmooth or banknote counting is inaccurate, it can be
solved through adjusting the vertical adjusting screw as well as the gap between
resistance rubber and rubber wheel. Then you can put in a banknote and hold, if you
feel the pull, the machine is workable.
Turn it clockwise to decrease gap in order to add friction (tight).
Turn it anticlockwise to increase gap in order to reduce friction (loose).
Error Code and Solution
The display may show error code when counting, which means there is problem with
the machine. Refer to the following sheet to find way to solve it.
Error Code
Reason
Solution
A or E10
Fake note detected by UV
Remove the fake note from the
stacker, press “START” to continue
b or E6X
Fake note detected by MG
Remove the fake note from the
stacker, press “START” to continue
C or EC0
Double note detected by IR
Remove the double note from the
stacker, press “START” to continue
d or E8X
Chain note or different
width note detected
Remove the suspicious note from
the stacker, press “START” to
continue
F or E4X
Half note detected
Remove the half note from the
stacker, press “START” to continue
CE1
Problem with the UV sensor
Clean the sensor or replace it
CE2
Problem with code disc
sensor or big motor
Replace the sensor or big motor
CE3
Problem with left counting
sensor
Clean the sensor or replace it

Premax PM-CC35D Specifications

General

Brand	Premax
Model	PM-CC35D
Category	Cash Counter
Language	English