22
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
Most console problems are the result of low batteries.
To replace the batteries, see assembly step 7 on
page 9.
If the console does not display your heart rate when
you use the handgrip heart rate monitor, see step 5 on
page 15.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must remove the parts
described below.
See assembly step 5 on page 8. Using a standard
screwdriver, release the tabs along the bottom edges
of the Rear and Front Upright Covers (19, 20), remove
the two M4 x 12mm Screws (57), and then remove the
Rear and Front Upright Covers.
Locate the Reed Switch (35). Turn a Crank Arm (60)
until a Magnet (39) is aligned with the Reed Switch.
Slightly loosen the two indicated M4.5 x 12mm Flange
Screws (36). Slide the Reed Switch slightly closer to or
away from the Magnet, and then retighten the Flange
Screws.
Turn the Crank Arm (60) so that the Magnet (39)
passes the Reed Switch (35) repeatedly. Repeat these
actions until the console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the parts that you removed.
36
35
39
60
MAINTENANCE AND TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
