7
3. If there are shipping brackets (not shown) on the
front of the Frame (1), remove the screws from
the shipping brackets and discard the screws
and the shipping brackets.
Set a sturdy piece of packing material (not
shown) under the front of the Frame (1).
Orient the Front Stabilizer (2) as indicated by the
sticker. Attach the Front Stabilizer to the Frame
(1) with two M10 x 68mm Screws (44).
Then, remove the packing material.
4. Orient the Upright (4) as shown.
Tip: Avoid pinching the Main Wire (41).
Attach the Upright (4) to the Frame (1) with four
M8 x 18mm Screws (42); start all the Screws,
and then tighten them.
Next, locate the wire tie (A) in the Upright (4).
Tie the lower end of the wire tie to the Main Wire
(41). Then, pull the upper end of the wire tie until
the Main Wire is routed through the Upright.
Tip: To prevent the Main Wire (41) from fall-
ing into the Upright (4), secure the Main Wire
with the wire tie (A).
Insert the excess Main Wire (41) into the
Upright (4).
4
44
1
2
4
3
42
41
42
1
Avoid pinching the
Main Wire (41)
A
A
To Next Page
Loading...
Need help?
General
