During maintenance or adjustments:
• Ensure that the weight is fully down, with the rope relaxed.
• Ensure that the hydraulic pressure is released.
• Ensure that the Tractor engine is switched off.
During Transport ensure:
• That the weight is fully down
• That the Post Driver is carried low to the ground and with the mast
crowded back for stability and maximum clearance from overhead
obstructions.
• Always drive at a safe speed and in complete control of the vehicle.
• Ensure that the hydraulic `Lock Plates ` are fitted for Mast forward tilt
and Mast side tilt
• Ensure the Slew arm locking pin is fitted.
WHEN NOT TO USE THIS MACHINE:
Never attempt to use this machine if you are not familiar or competent with the
machine.
Never use a machine until you have read and fully understood the operator
handbook, are familiar with and practiced the controls, and `on site` specific
risk assessment has been completed and understood by all persons.
Never use a machine that is poorly maintained
Never use a machine on which the hydraulic system shows signs of wear or
damage.
Never fit, or use a machine on a tractor that does not meet the manufacturers
minimum specification level.
To Next Page
Loading...
Need help?
General
