protech P200S User Manual

15
TRAPPING POINT
CRUSHING ZONE
Rock Spike Control
The rock spike control valve is used to maintain sufficient clearance of the
support collar from the head of the rock spike.
Left and right leg controls
Manual operation
Remove lock pin and lower leg to desired height. Re-insert lock pin when
desired level is reached.

protech P200S Specifications

General

Brand	protech
Model	P200S
Category	Construction Equipment
Language	English

Summary

EC Declaration of Conformity

Important Safety Notice

Introduction

P200S Product Specification

P200S Part References

Safety Information

Potential Significant Dangers

Lists key hazards like crushing, trapping, electrocution, and flying debris.

Pre-Operation Requirements

Operating Restrictions

Machine Safety Stickers

Control Functions of the Post Driver

Slew Arm Control

Explains the operation and safety zones of the slew arm control lever.

Telescopic Arm Control

Hydraulic Rear Leg Control

Mast Forward Tilt Control

Mast Side Tilt Control

Driver Weight Control

Rock Spike Control

Left and Right Leg Controls

Installation of the Post Driver

Transporting the Post Driver

Safe Use of the Post Driver

Safe Working Zone Compliance

Operator must remain within the defined safe working zone during operation.

Lock Pin and Plate Management

Procedures for removing and storing lock pins and safety plates.

Post Insertion Procedure

Safe Use of the Rock Spike

Storage of the Post Driver

Maintenance of the Post Driver