PDC 18-4 Compact
11
GB
– Protect the machine from moisture.
– Protect the cable from heat, oil and sharp
edges.
– Check the plug and the cable regularly and
should either become damaged, have
them replaced by an authorised after-sales
service workshop.
5.3 Emission levels
Levels determined in accordance with EN
60745 are typically:
Vibration emission value a
h
(vector sum for
three directions) and uncertainty K mea-
sured in accordance with EN 60745:
The specified emissions values (vibration,
noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise
loads during operation.
– They represent the primary applications of
the power tool.
Increase possible for other applications, with
other insertion tools or if not maintained ad-
equately. Take note of idling and downtimes
of machine!
6Operation
6.1 Charger cable holder[3-3]
Unwind the cable completely from the
recess before using the charger.
6.2 Changing the battery pack
Removing the battery pack[2 B]
Inserting the battery pack [2 A]
6.3 Charging the battery pack [3]
L
The battery pack is delivered partially
charged. Charge the battery pack com-
pletely before using for the first time.
The LED
[3-2]
on the charger indicates the
respective operating status of the charger.
6.4 Light and battery capacity indi-
cator
The LED on the lamp
[1-3]
is both a
light and a battery capacity indicator
[1-2]
.
The LED automatically indicates the charging
state of the battery pack (not NiCd and NiMH
battery packs) when the on/off switch
[1-8]
is pressed.
Drilling
Sound pressure level L
PA
= 69 dB(A)
Noise level L
WA
= 78 dB(A)
Uncertainty K = 3 dB
Impact drilling
Sound pressure level L
PA
= 99 dB(A)
Noise level L
WA
= 108 dB(A)
Uncertainty K = 3 dB
CAUTION
When working with noise
Damage to hearing
X
Always use ear protection.
Drilling into metal a
h
< 2,5 m/s
2
K = 1,5 m/s
2
Fastening a
h
< 2,5 m/s
2
K = 1,5 m/s
2
Impact drilling into
concrete
a
h
= 16,8 m/s
2
K = 3,0 m/s
2
LED yellow - lit continu-
ously
Charger is ready to use.
LED green - flashing
quickly
Battery pack is charged to
maximum capacity.
LED green - flashing
slowly
Battery pack is charged with
reduced current. LiIon is
charged to 80 %.
LED green - lit continu-
ously
Charging is complete or is not
restarted as current charge
status is greater than 80%.
LED red - flashing
General fault display, e.g.
incomplete contact, short cir-
cuit, defective battery pack,
etc.
LED red - lit continuously
Battery temperature is out-
side the permitted range.
To Next Page
Loading...
Need help?
General
