11
The device will not focus. Incorrect setting. Adjust the device in accordance with
section “Operation”. Check the outer
surfaces of the lens and eyepiece; where
necessary, wipe them free from dust,
condensate, frost, etc. In cold weather, you
can use special anti-fogging coatings (as,
for example, for corrective glasses).
Impact point does not
coincide with aiming point.
Display calibration required. Calibrate the display in accordance with
the instruction in the section, “Display
Calibration” (see below).
The device is not securely mounted
on the sight, or the sight on the
weapon.
Check that the device is rmly xed on the
sight and that the mounting of the sight to
the weapon is secure.
Ensure that you are using the very type of
ammunition that was previously red from
your weapon.
If you zero a sight in summer and then use
it in winter (or vice versa), some change
in the zero point of the zeroing cannot be
discounted.
The attachment slides off
the sight during ring.
Adapter insufciently clamped.
Unsuitable insert selected.
Select a suitable insert and clamp the
adapter as recommended.
Cannot open the adapter
clamp.
Unsuitable insert selected. Select a suitable insert. Check for a gap
between the lips of the adapter.
By following the link below you can nd answers to the most frequently asked questions
https://www.pulsar-nv.com/glo/support/faq/79
Electromagnetic compatibility.
This product complies with the requirements of European standard EN 55032: 2015, Class A.
Caution: Operating this product in a residential area may cause radio interference.
Attention! Forward digital night vision devices require a licence if exported outside your country.
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
To Next Page
Loading...
Need help?
General