MAINTENANCE
23
Fig 26
Draining the carburetor
Consult your local hazardous waste management in your area for the proper way to dispose
of used fuel.
CAUTION!
Engine Long Term Storage:
Storage and T
ransportation of the Generator: (See Fig 2
6)
•
Turn the fuel valve to the OFF position.
•
Turn the battery switch to stop.
•
Position a suitable container under the carburetor drain screw to catch fuel; loosen and remove the screw.
•
Allow fuel to drain completely into container, be sure to wipe up any spilled fuel right away.
•
Retighten drain screw, taking care that the gasket seal is in place.
•
Remove any debris that has collected on the generator and around the muffler and controls. Use a vacuum cleaner to
pick up loose debris. If dirt is caked on, use a soft bristle brush.
•
Inspect air cooling cylinder fins and flywheel fan. Remove any debris if obstructed.
•
For short-term storage, start generator once every 7 days.
•
For long-term storage, add fuel stabilizer to prevent stale fuel from causing varnish and gum deposits in the fuel
system and carburetor.
•
Store in a sheltered location and use a suitable cover to protect from dust.
•
Remove the spark plug and pour about 1 teaspoon of 10W30 Engine oil into the spark plug hole. Reinstall the spark plug.
With the RUN/STOP switch in the STOP position pull the recoil starter cord several times to coat the cylinder walls with oil.
•
Slowly pull the recoil starter until you feel the engine build compression (when you feel resistance). Leave the Engine in
this state as this will prevent corrosion on the cylinder walls if stored for a long period of time.
To Next Page
Loading...
Need help?
General
