13
SYSTEM DEFINITIONS
Bump & Go (Horizontal)
Horizontal Obstruction Sensors—Rotational and Non-Rotational Arms restart their function a maximum of 3 times
before Rotational Arm goes back to the original Stow Position or until obstruction is removed and arms secure the WMD.
Blinking lights on Marker Light, Occupant Interface and Occupant Switch on Driver Interface while a steady rapid Alert
Beep is heard.
AND
Bump & Go (Once Obstacle is Removed)
Operator presses Secure Button on Driver Interface, the QUANTUM® continues from where it left off to finish function in progress
(illustrated Secure Position). Blinking lights on Marker Light, Occupant Interface and Occupant Switch on Driver Interface while a
steady Alert Beep is heard. Once WMD is Secure, lights are solid and Alert Beep is silent.
Or, occupant presses Occupant Interface, the Rotational Arm goes back to the Stow Position (vertical). Blinking lights on Marker
Light, Occupant Interface and Occupant Switch on Driver Interface while a steady Alert Beep is heard. Once QUANTUM® is in Stow
Position, lights are solid and Alert Beep is silent.
Remove ALL Obstacles from Inside QUANTUM® Arms
Because it will affect the performance of the QUANTUM®
OR
To Next Page
Loading...
Need help?
General
