Qlima PH534 User Manual

Protect floors when rolling over wood floors. Do not attempt to roll the unit
over objects.
• The unit must be placed within reach of a properly rated grounded socket.
• Never place any obstacles around the air inlet or outlet of the unit.
• Allow at least 45cm of space away from the wall for efficient air conditioning.
• The hose can be extended, but it is the best to keep the length to minimum
required. Also make sure that the hose does not have any sharp bends or sags.
INSTALLATION INSTRUCTIONS
EXHAUSTING HOT AIR
In the Cool Mode the appliance must be placed close to a window or opening
so that the warm exhaust air can be ducted outside.
First position unit on a flat floor and make sure there’s a minimum of 12”
(30cm) clearance around the unit, and is within the vicinity of a single circuit
outlet power source.
1
Extend either side of the hose {Fig.1 )and screw the hose inlet (Fig.2).
2
Extend the other side of the hose and screw it to the hose outlet (Fig.3).
3
Install the hose inlet into the unit (Fig.4).
4
Affix the hose outlet into the window slider kit and seal. (Fig.5 &6).
Lock
Slide onto
Cut on opposite
side of hole.
Fig. 4
Your window slider kit has been designed to fit most standard vertical
and horizontal window applications, however, it may be necessary for you
to modify some aspects of the installation procedures for certain types of
windows. The window slider kit can be fastened with screws.
G
If the window opening is less than the minimum length of the window
slider kit, cut the end without the hold in it short enough to fit in the
window opening. Never cut out the hole in window slider kit.
WINDOW SLIDER KIT INSTALLATION
1
Parts:
A) Panel
B) Panel with one hole
C) Panel without hole (maybe not supplied)
D) Screw to lock window kit in place
Fig. 1
Fig. 2
Fig. 3
Fig. 5
Fig. 6
Vertical
Window
Window slider
Horizontal
Window
Window slider
4
52

Qlima PH534 Specifications

General

Type	Monobloc mobile air conditioner
Noise level	65 dB
Compressor type	Rotary
Airflow (high speed)	330 m³/h
Refrigerating medium	R290
Adjustable thermostat	Yes
Cooling capacity (max)	- BTU/h
Dehumidifying capacity	4.5 l/h
Air conditioner functions	Cooling, Dehumidifying, Heating
Refrigerating medium weight	260 g
Suitable for room volume up to	105 m³
Cooling capacity in watts (max)	3200 W
Heating capacity in watts (max)	2900 W
Heating capacity in watts (nominal)	- W
Cooling energy efficiency (EER, W/W)	2.6
Heating energy efficiency (COP, W/W)	2700
Current	8.4 A
AC input voltage	220-240 V
AC input frequency	50 Hz
Energy efficiency class (cooling)	A
Energy efficiency class (heating)	A+
Annual energy consumption (cooling)	- kWh
Hourly energy consumption (cooling)	1.2 kWh
Hourly energy consumption (heating)	1 kWh
Product color	White

Weight and Dimensions

Depth	350 mm
Width	435 mm
Height	715 mm
Weight	31000 g