To Next Page

To Previous Page

LED-DISPLAY:

Press LED button.

Press this button to turn on and turn off the display on the indoor unit.

Press this button more than 5 seconds(some units)

Keep pressing this button more than 5 seconds, the indoor unit will display the actual room

temperature. Press more than 5 seconds again will revert back to display the setting

temperature.

ECO FUNCTION

Press this button to enter the energy efficient mode.

NOTE: This function is only available under COOL mode.

ECO operation:

Under cooling mode, press this button, the remote controller will adjust the temperature automatically

to 24°C, fan speed of Auto to save energy (only when the set temperature is less than 24°C). If the set

temperature is above 24°C, press the ECO button, the fan speed will change to Auto, the set temperature

will remain unchanged.

NOTE

Pressing the this button, or modifying the mode or adjusting the set temperature to less

than 24°C will stop ECO operation. Under ECO operation, the set temperature should be 24°C or

above, it may result in insufficient cooling. If you feel uncomfortable, just press the ECO button

again to stop it.

Silence function

Keep pressing Fan button for more than 2 seconds to activate/disable Silence

function(some units). Due to low frequency operation of compressor, it may result in

insufficient cooling and heating capacity. Press ON/OFF, Mode, Sleep, Turbo or Clean

button while operating will cancel silence function.

FP function

The unit will operate at high fan speed (while compressor on) with temperature

automatically set to 8°C.

NOTE: This function is for heat pump air conditioner only.

Press this button 2 times during one second under HEAT Mode and setting temperature of

16 C/60 F to activate FP function. Press On/Off, Sleep, Mode, Fan and Temp. button while

operating will cancel this function.

LOCK function

Press together turbo button and Humidity button at the same time more

than 5 seconds to activate Lock function. All buttons will not response

except pressing these two buttons for two seconds again to disable locking.

Remote-man_RG10 EU ('21) V2.indd 29Remote-man_RG10 EU ('21) V2.indd 29 16-11-2021 17:1516-11-2021 17:15

Qlima RG10 User Manual

Questions and Answers: