TURBO function
Press TURBO button to make the unit work extra hard. In COOL/HEAT/FAN mode, when you select TURBO
feature, it will use the highest fan setting and use the preset temperature of 16°C in COOL mode and 31°C
in HEAT mode. Press it again to inactivat the pre-setting status.
Mute mode
Press Mute button to activate mute mode, the unit will blow the lowest fan setting and the compressor
works at lowest capacity. This may result in insufficient cooling and heating capacity. Press it again to cancel
mute mode.
I FEEL mode
Press I Feel button to enable the remote control to measure the temperature at its current location and send
this signal to the air conditioner to enable the air conditioner to optimize the temperature around you and
ensure maximum comfort. Press it again to cancel the I FEEL mode.
ECO mode
Press the ECO button to enable the unit to work in an economic situation like adjusting the compressor
frequency and fan speed. Press it again to cancel the ECO mode.
Lock mode
Press Mode and Timer together to lock or unlock the keyboard, when locked, all buttons can’t be operated
until they are unlocked. The remote controller screen shows “LO”.
E MAINTENANCE
Cleaning the front panel
1. Turn off the device and pull the plug out of the socket.
2. Grab the front panel at position “a” and pull it towards you.
3. Clean with a soft, dry cloth.
Use lukewarm water (max. 30˚ C) to remove persistent dirt.
4. Never use volatile substances like gasoline, or an abrasive to remove dirt.
5. Never spray water on the indoor unit.
Danger! Electrical shock!
6. Replace the front panel and close it by pressing down position “b”.
Cleaning the air filter
The air filter must be cleaned regularly.
Do this as follows:
1. Turn off the device completely.
- Open the front panel.
- Grab the lever and pull the filter out.
4
50
To Next Page
Loading...
Need help?
General
