70
1. SAFETY PRECAUTIONS
The following should be always observed for safety:
• Be sure to read the following WARNING before installing the airconditioner.
• Be sure to observe the cautions specified here as they include important items related to safety.
• After reading this instructions, be sure to keep it together with the owners manual in a handy place for
future reference.
The air conditioner contains a refrigerant and can be classified as pressurized equipment. Therefore always
contact an authorized air conditioning engineer for installation and maintenance of the air conditioner. The
air conditioner must be inspected and serviced on an annual base by an authorized air conditioning
engineer.
The specifications of the fuse are printed on the circuit board ,such as :
T3.15AL/250VAC, T5AL/250VAC, T3.15A/250VAC, T5A/250VAC, T20A/250VAC, T30A/250VAC,etc.
NOTE: For the units with R32 or R290 refrigerant , only the blast-proof ceramic fuse can be used.
G
WARNING
Do not install it yourself.
• Incorrect installation could cause injury due to fire, electric shock, the unit falling or leakage of
water. Consult your dealer from whom you purchased the unit or an authorised installer.
Install the unit securely in a place which can bear the weight of the unit.
• When installed in an insufficiently strong place, the unit could fall causing injury.
Use the specified electrical wires to connect the indoor and outdoor units securely and attach the
wires firmly to the terminal board connecting sections so the stress of the wires is not applied to
the sections.
• Incorrect connection and fixing could cause a fire.
Be sure to use the provided or specified parts for the installation work.
• The use of defective parts could cause an injury due to a fire, electric shock, the unit falling,
etc.
Perform the installation securely referring to the installation instruction.
• Incorrect installation could cause a personnel injury due to fire, electric shock, the unit falling
or leakage of water.
Perform electrical work according to the installation manual and be sure to use an exclusive
circuit.
• If the capacity of the power circuit is insufficient or there is incomplete electrical work, it could
result in a fire or an electric shock.
Check that the refrigerant gas does not leak during installation or after installation is completed.
• Leaking refrigerant is bad for the environment and could cause global warming.
Attach the electrical part cover to the indoor unit and the service panel to the outdoor unit
securely.
• If the electrical part covers off the indoor unit and/ or the service panel of the outdoor unit are
not attached securely, it could result in a fire or electrical shock due to dust, water, etc.
4
70
To Next Page
Loading...
Need help?
General
