87
4
87
10.2 The wire connection between indoor unit and outdoor unit.
Align the two connectors and insert into each other until they are fixed with a clicking sound. The Y/G wire
should be connected individually. Secure the cable onto the control board with cord clamp.
a. Insulate unused wires with PVC electrical tape. Arrange them so that they do not touch any electrical
or metal parts.
b. Replace the wire cover on the side of the unit, and screw it in place.
NOTE: If the cable clamp looks like the following, please select the appropriate through-hole according to
the diameter of the wire.
When the cable is not fasten enough, use the buckle to prop it up , so it can be clamped tightly.
To Next Page
Loading...
Need help?
General
