29
4
Symptoms Causes Measures to be taken
Heater doesn’t ignite The child safety catch lights up Turn the child safety catch off
The fuel indicator lamp
doesn’t work
The tank is empty Fill the tank
The tank is deformed Replace the tank
Dirt particles dust or water on the filter and / or in the fixed
tank
Clean the fixed tank and the fuel filter.
Power loss
The fuel indicator flashes
The fuel indicator flashes Fill the tank
A poor quality fuel has been used.
Remove the fuel from the two tanks, then rinse with the
correct fuel.
Abnormal combustion
A poor quality fuel has been used.
Poor ventilation Ventilate regularly
Dust on the ventilator filter Clean the ventilator filter
Unpleasant smells
A poor quality fuel has been used
Remove the fuel from the two tanks, then rinse with the
correct fuel.
No fuel in the tank Fill the tank
Fuel leakage or spilled fuel
Do not use any more and contact your dealer
Fuel leakage
Move the heater, the tank is not empty
A poor quality fuel has been used.
AUTOMATIC DEACTIVATION
This heater is fitted with a safety system that ensures that it switches off automatically after 36 hours continuous
operation. If desired, you can switch the heater on again by pressing the ON/OFF button
2020
(see section D).
I CHILDPROOF LOCK
The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is
burning and the childproof lock is on, the heater can only be switched off. Other functions are blocked then. If the
heater has already been switched off, the childproof lock also prevents accidental ignition of the heater.
Activate the
childproof lock by pressing the CHILDLOCK key and holding it down for more than 3 seconds. The childlock indicator
will appear on the information display (Fig. O), indicating that the childproof lock has been activated. Switch off the
childproof lock by pressing the CHILDLOCK key and holding it down for more than 3 seconds once again.
J THE CORRECT USE OF ‘SAVE’
The ‘SAVE’ function allows you to limit the temperature. When this function is activated, the heater will automatically
switch off, when the room temperature exceeds the set temperature by 3°C. Subsequently, when the room temperature
has dropped again to the set temperature, the heater will automatically switch on again.
Activate the ‘SAVE’ setting by
pressing the appropriate
2121
key. The SAVE indicator light will light up. Switch off the function by pressing the SAVE key
once again.
G
Without the ‘SAVE’ setting your heater will maintain the set temperature by approximation as well,
by adjusting its heating capacity. ‘SAVE’ is an economy setting, which you can use when, for instance,
you are not present in the room or to keep it frost-free.
K THE ‘OIL’ INDICATOR
If the low fuel level indicator lights up in combination with a short tone, then the fuel tank is empty. The heater
will automatically burn at its lowest setting for a period of about 80 minutes. The fuel tank must be replenished.
E remove the removable tank from the heater and fill it with new fuel (outside the living space in a safe place)
(see chapter B)
If you take no action, the fuel tank will be emptied and the display will indicate “E 03” (fig. Q). The heater is
automatically turned off.
To ignite the heater once more, fill the tank and wait a few minutes.
Then press the ON / OFF button
2020
.
To Next Page
Loading...
Need help?
General
