76
2. Assembly and Connections
QLOCKTWO CLASSIC is suitable for use as a free-standing model and for wall
installation.
The plug of the power supply unit serves as a disconnecting device from the mains
supply. The socket must be located close to the QLOCKTWO CLASSIC and be easily
accessible.
IMPORTANT Please note the following in order to avoid material damage:
■
Carefully insert the miniature USB plug into the USB connection socket on the back
of the casing.
■
For all stainless steel front covers: use cotton gloves (included with delivery).
2.1 Free-standing use
IMPORTANT QLOCKTWO CLASSIC with a GOLD, SILVER & GOLD, PLATINUM,
METAMORPHITE, GLINTSCAPE front cover is not suitable for use as a free-standing
model. See the mounting template, images
1
to
3
.
2.2 Wall installation
IMPORTANT Please note the following in order to avoid material damage:
■
Only screw in the retaining screw on the back of the casing manually; do not use
■
any tools.
■
Observe the load-bearing capacity of the chosen wall and select a suitable fastener
■
for this wall, e.g. dowels and screws for brickwork.
■
No supply lines may be present near the drill holes.
■
If you feel resistance when hanging your QLOCKTWO CLASSIC into the wall
mounting bracket (e.g. as a result of unfavourably positioned cables), do not use
force to press or turn your QLOCKTWO CLASSIC into the right position.
Power supply from a wall connection:
See the assembly template, images
1
to
10
, for wall mounting + electrical connections.
Power supply from a power socket:
See the assembly template, images
1
to
10
,
for wall mounting.
The electrical connection is the same as for
wall mounting, see the mounting template,
images
1
and
3
>
Guide the mains cable through the cable duct
on the wall mounting bracket.
If the mains cable gets between the wall mounting
bracket and the body when hanging the clock up,
it can be pushed back into the cable duct with a ruler.
WARNING
Serious to fatal injury caused by electric power
■
Do not pull electric cables; only pull out the plugs.
■
Lay cables so that they cannot be bent or get caught and are
not found in passages.
■
Check all cables for visible damage before connecting them to
the power supply. Do not connect your QLOCKTWO CLASSIC to
the power supply in the event of any damage.
■
Have electrical connection carried out by electricians.
■
Cut off the power supply and check to ensure that there is no
voltage before commencing with wall mounting.
■
Comply with acceptable electric data for the power supply, see
Section 4 on "Technical Data".
■
Do not touch cables and plugs with wet hands.
EN
To Next Page
Loading...
Need help?
General
