QTech QT290 User Manual

PREVENT STATIC SPARKING
FIRE/EXPLOSIONS
Vapors created when spraying can be ignited by sparks.
To reduce the risk of re, always locate the sprayer at least 20 feet (6 m.) away
from spray area. Do not plug in or unplug any electrical cords in the spray area.
Doing so can cause sparks which can ignite any vapors still in the air. Follow the
coating & solvent manufacturers safety warnings and precautions.
MEDICAL ALERT INJECTION INJURIES
If any uid appears to penetrate your skin, GET EMERGENCY MEDICAL CARE
AT ONCE. DO NOT TREAT AS AN ORDINARY CUT. High pressure uids from
spray or leaks are powerful enough to easily penetrate the skin and cause
extremely serious injection injury, leading to the possible need for amputation.
+ NEVER point the spray gun at anyone or any part of the body.
+ NEVER put your hand or ngers over the spray tip. Do not use a rag or
any other materials over your ngers. Paint will penetrate through these
materials and into the hand.
+ NEVER try to stop or deect leaks with your hand or body.
+ ALWAYS have the tip guard in place when spraying.
+ ALWAYS lock the gun trigger when you stop spraying.
+ ALWAYS remove tip from the gun to clean it.
+ NEVER try to "blow back" paint, this is not an air powered sprayer.
+ ALWAYS follow the PRESSURE RELIEF PROCEDURE before cleaning or
removing the spray tip or servicing any system equipment.
+ Be sure the equipment safety devices are operating properly before each use.
+ Tighten all of the uid connections before each use.
+ NEVER alter equipment in any manner.
+ NEVER smoke while in spraying area.
+ NEVER spray highly ammable materials.
+ NEVER use around children.
+ NEVER allow another person to use sprayer unless he is thoroughly
instructed on its safe use and given this operator’s manual to read.
+ ALWAYS wear a spray mask, gloves and protective eye wear while spraying.
+ ALWAYS ensure re extinguishing equipment is readily available and
properly maintained.
10
QTech QT290 Airless Sprayer
NEVER LEAVE SPRAYER UNATTENDED WITH PRESSURE IN THE SYSTEM.
FOLLOW PRESSURE RELIEF PROCEDURES AT ALL TIMES.
ALWAYS INSPECT SPRAYING AREA
+ Keep the spraying area free from obstructions.
+ Make sure the spraying area has good ventilation to safely remove
vapors and mists.
+ NEVER keep ammable material in spraying area.
+ NEVER spray in vicinity of open ame or other sources of ignition.
+ The spraying area must be at least 6 metres away from spray unit.
SPRAY GUN SAFETY
+ ALWAYS set gun safety lock in the "LOCKED" position when not in use
and before servicing or cleaning.
+ NEVER remove or modify any part of the gun.
+ ALWAYS REMOVE THE SPRAY TIP when cleaning.
Flush unit at the LOWEST POSSIBLE PRESSURE.
+ ALWAYS check operation of all gun safety devices before each use.
+ Be very careful when removing the spray tip or hose from the gun.
A plugged line will contain uid under pressure. If the tip or line is plugged,
follow the PRESSURE RELIEF PROCEDURE.
TIP GUARD
+ ALWAYS have the tip guard in place on the spray gun while spraying. The
tip guard alerts you to the injection hazard and helps prevent accidentally
placing your ngers or any part of your body close to the spray tip.
SPRAY TIP SAFETY
+ Use extreme caution when cleaning or changing spray tips. If the spray tip
clogs while spraying, engage the gun safety latch immediately. ALWAYS
follow the PRESSURE RELIEF PROCEDURE and then remove the spray
tip to clean it.
+ NEVER wipe off build up around the spray tip.
11
Brought to you by Aristospray

QTech QT290 Specifications

General

Brand	QTech
Model	QT290
Category	Paint Sprayer
Language	English