6-01492-04 Rev A, December 2013
*6-01492-04*
© 2013 Quantum Corporation. All rights reserved. Quantum, the Quantum logo, DLT, DLTtape, the DLTtape logo, SuperLoader,
Scalar, DXi, StorageCare, StorNext, GoProtect, and Vision are registered trademarks of Quantum Corporation and its affiliates
in the United States and/or other countries. All other trademarks are the property of their respective owners. Quantum
specifications are subject to change.
Quantum Scalar i500:
Rackmount Kit Installation
All Scalar
®
i500 libraries taller than 14U must be installed in a rack. The rack
secures the bottom module, and all other modules are then secured to the
bottom module.
The Rackmount kit secures your library within a rack. These instructions explain
how to install your library into a rack, and how to install additional modules into
an existing rack.
Installing the modules into the rack requires at least two people.
WARNING: All libraries taller than 14U must be installed in a rack having a
main protective earthing (grounding) terminal, and power must
be supplied via an industrial plug and socket-outlet and/or an
appliance coupler complying with IEC 60309 (or an equivalent
national standard) and having a protective earth (ground)
conductor with a cross sectional area of at least 1.50 mm
2
(14
AWG).
To ensure proper airflow and access space, allow 60 cm
(24 inches) in the front and back of the library.
WARNING: Under no circumstances should a rack be moved while loaded
with one or more modules.
To Next Page
Need help?
General