DVD operations
Before enjoying DVD/Video CD/CD
The On-Screen menu language of your player has been factory pre-set to Spanish. If you
want to change the menu language to other language, please refer to "Initial settings /
General setup / OSD lang". In the explanation below it is assumed that English has been
selected as menu language.
Basic play
1.Switch on the DVD player (power switch is
located on the right side of the unit.)
NOTE: 1).Make sure that all the connections
including connections to AC adaptor, other
AV equipment etc. have been completed
before switching the POWER knob to the
"ON"position.
2). After switching the unit "OFF" wait serval
seconds before turning the unit back "ON"
The unit may malfunction if the unit is
switched back "ON" immediately after
switching "OFF".If a malfunction occurs,
switch the unit "OFF" and wait serval
seconds before turning it "ON"again.
2.Press SWITCH button to set the unit in DVD
mode.
3. Push the open button to open the disc cover.
4. Place a disc onto the disc compartment. Hold the disc without touching either of its
surfaces, position it with the printed title side facing up, align it with the guides, and place it in
its proper position.
5. Close the disc cover, after closing the disc cover , play begins. The player starts to read the
disc immediately.
6. When a menu screen appears on the TV, move the navigation buttons or press the numeric
buttons to select preferred track number, then press ENTER button to confirm.
7. Press NEXT or PREV button to play the next or previous chapter.
8. To stop play and return to the menu screen, press TITLE button, or MENU button.
To Next Page
Loading...
Need help?
General