To Next Page

To Previous Page

LTE Standard Module Series

EC200U&EG915U_Series_PPP_Application_Note 12 / 28

4 PPP Connection Modes

4.1. Data Mode and Command Mode

The module communicates with application via USB or UART port (including AT commands and data).

USB and UART ports have two working modes: data mode and command mode.

The two ports are in command mode before PPP is set, and the module can execute AT commands in this

mode. When PPP negotiation is started, the two ports enter data mode, and remain in the mode when the

PPP connection is set. If the PPP connection is not successfully established, the two ports will be in the

command mode. In data mode, the module cannot execute AT commands.

EC200U and EG915U series modules provide convenient methods to switch between the two modes.

4.1.1. Switch from Data Mode to Command Mode

4.1.1.1. Change DTR Level to Switch from Data Mode to Command Mode

When the PPP connection has been established and USB/UART port is in data mode, change the DTR

level from low to high to switch from data mode to command mode (AT&D1 must be executed first). After

the switch is successful, the module will return OK.

4.1.1.2. Use Sequence +++ to Switch from Data Mode to Command Mode

After the PPP connection is successfully established, use +++ to switch the USB/UART port from data

mode to command mode. To prevent the +++ escape sequence from being misinterpreted as data, the

following requirements should be followed:

1) Do not input any characters within 1 s or longer before inputting +++.

2) Input +++ within 1 s, and no other characters can be inputted during this period.

3) Do not input any characters within 1 s after inputting +++.

When +++ is received, the USB/UART port will switch from data mode to command mode, and the

module will return OK.

Quectel EG915U Series Application Note

Other manuals for Quectel EG915U Series