USER’S MANUAL
AUTO BATTERY TESTER
8
3.2 Tester Startup
Tester automatically starts up after the clamps are correctly connected, and
displays the BAT TOOL startup interface. After 2seconds, it automatically
enters the battery test program.
BATTERY TOOL
Ver 1.00
3.1.2 Connecting the Analyzer Before Testing
Before the test, please use the wire brush and alkaline cleaner clean battery
pole column, as well as grease and dust have error on test results.
At the start of the test, to ensure that all of the car electronics has closed
the door closed, and the ignition key is turned off.
The red test cli p to the battery positive electrode, the black test cli p to
battery cathode. again. Tester has an automatic protection function, if the
red and black cli p is negative, screen is not brig ht, but it will not have any
adverse effects on tester and the motor load.
In order to ensure a good connection, please waggle a few times to test
cli ps..
Tester require two cli ps polar to contact with the battery polarity is good,
but with bad connection, the tester will not be able to boot. If this happens,
please clean the terminal after properly connected
To Next Page
Loading...
Need help?
General