7. Rotate trim wires and trim wire rotator (on control
shaft) to the position that neutral is desired when
control handle is reinstalled.
50092
a
-
Trim Wires and Rotator
b
-
Spacer Disc
c
-
Standard Position of Trim Wires and Rotator
d
-
If Trim
Wires
and Rotator are Moved to This Angle (or Any Other
Angle) from the Standard Position, the Control Handle Must
Also Be Installed (on Control Shaft) in the Same Angle (thus
Neutral is Changed to
Thus
Angie from Standard Neutral
Position)
8. Reinstall handle to control shaft (make certain full
forward and full reverse can be achieved) at desired
location.
a
-
Trim Wires
b
-
Control Handle
50092
AWARNING
Control handle set screw must be torqued to specifica-
tion. Failure to tighten set screws securely could allow
control handle to disengage, with subsequent loss of
throttle/shift control.
9.
While holding is on hub of control handle, move
handle until access to set screw is achieved. Torque
control handle set screw to 60 Ibs. in. (7
N.m.)
10.
Push the “Throttle-Only” button onto control shaft.
50063
11. Reconnect trim wires to terminals on trim switch.
STBD. TRIM
PORT TRIM
12. Place trim switches into handle, and install trim
switch retainer/cover onto handle.
13. Reconnect trim wire connections to ignition switch
connections.
-
12-
To Next Page
Loading...
Need help?
General