Remote Control Mounting
CAUTION
This trim control can be connected only to Power
Trims that are equipped with a 2-solenoid trim pump. If
Power Trim is equipped with only one solenoid, a Trim
Solenoid Kit must be purchased and installed on
Power Trim pump.
Locating and Drilling Mounting Area
for Remote Control
ACAUTION
Area directly under control must be free of obstruc-
tions (bulkhead, braces, etc.) Cables always must pro-
trude from rear of control, extending straight-down
and parallel to each other. Radius (at point where
cables are routed toward stern of boat) must not be less
than 12”
(30.5cm).
This will prevent placing a load or
bind on control cables that would result in hard shifting
or binding throttle action.
Locate area where control will be mounted in boat.
Be sure to allow sufficient clearance for control
handles when they are in full forward and full
reverse position.
Place Template (provided on last page) over area
where control is to be mounted.
Cut and drill mounting area as indicated on tem-
plate.
I+“-“‘““-I
(Metric: 1
"
=
25.4mm)
24975
a
-
9-3/8 in. (24.45cm) Radius Provides 2 in. (51mm)
Hand Clearance
b
-
7-3/8 in. (19.37cm) Radius Maximum Travel Available
c
-
Mounting Surface
d
-
Dual Console Control
Clearance Requirements
Mounting Control
1. Place control modules back-to-back, then position
a mounting bracket onto each module and secure
brackets and modules together with two 4 in.
(10.2cm)
screws and locknuts. Do not tighten lock-
nuts securely at this time).
50092
a
-
Mounting Brackets
b
-
Screws and Locknuts
c
-
Plastic Sleeve
Mounting Brackets Installed on Control Modules
2. Insert
wellnut
fasteners into drilled holes with
flange against the outer surface.
NOTE: It may be helpful to thread a mounting screw
into
wellnut
when inserting into drilled hole.
Mounting Screw
w-+
Mounting Surface
Wellnut
To Next Page
Loading...
Need help?
General