Quicksilver 88688A23 User Manual

Starboard Side Control
Module Cable Installation
All MerCruiser Models
(Except MIE) and Outboard
Models (250 HP 3 Litre and
Below)
IMPORTANT: Control modules are stamped port and
starboard and control cables must be installed ac-
cordingly.
Before tightening cable fastener locknut, be sure that
pin on end of cable fastener is completely thru cable
end and shift/throttle lever. A pin, that is partially thru
cable and lever, may cause fastener to bend when
locknut is tightened.
Shift Cable
a - Cable Fastener Locknut
b
- Cable Fastener
c
- Shift Cable
d
- Cable Anchor Barrel
Torque shift cable fastener locknut to 20 to 25 Ibs. in.
(2.3 to 2.8 N.m.)
Throttle Cable
a - Cable Fastener Locknut
b
- Cable Fastener
c Throttle Lever
d
- Spacers (From Parts Bag)
e - Throttle Cable
f Cable Anchor Barrel
Torque throttle cable fastener locknut to 20 to 25 lbs.
in. (2.3 to 2.8 N.m.)
50030
a - Screws
b - Cable Retainer
c - Access Cover
Position access cover and cable retainer onto back
side of control and secure both using 2 screws. Torque
screws to 60 Ibs. in. (7 N m
)
-4-

Quicksilver 88688A23 Specifications

General

Brand	Quicksilver
Model	88688A23
Category	Remote Control
Language	English