®
3
MAKING CONNECTIONS
Before making any connections, always ensure your audio system is either
turned down or turned off in order to protect more sensitive components
from damage caused by loud turn-on or plug-in transients. The BT-Pro
uses a USB Mini-B connector and cable for its power requirements. Use
the included ‘Mini-B to TYPE A’ USB cable and connect to a computer,
USB hub or the included USB wall charger. You may also use any
standard USB wall charger that is included with most phones and tablets,
as the BT-Pro will only draw a small amount of current.
To block DC current, activate the
transformer isolation by switching
the LEFT-ISO and RIGHT-ISO to
the ‘right’ position.
IMPORTANT NOTE: Although the BT-Pro is equipped with protective
transformers that may be inserted into the signal path to protect it from
48V DC, you should turn the phantom power off on your console as it
is not needed. If only a global phantom power switch is present, then
make sure the transformers are inserted!
TYPE A USB
Fits most laptops and computers
OFFON
BE SURE THAT THE BT-PRO IS TURNED OFF BEFORE CONNECTING
THE POWER CABLE to avoid initial intermittent power spikes to the
electronics.
TYPE Mini-B USB
Used to connect to the BT-Pro
To Next Page
Loading...
Need help?
General
