Phone Programming
Page 5
Keypad
On-Site Programming:
Step 1. To Begin Program Mode
a. Press Enter
Step 2. To Program Emergency Numbers
a. Press 1, Enter, (phone number), Stop
Note: To program numbers 2-5, repeat step 2A
Step 3. To Program Location Message
a. To turn on message Press 1, 3, Enter, 2
b. Press 6, Record (speak message) Stop (to replay message
Press 6, Play)
c. Program frequency of message Press 1, 3, Enter, __
0 = Turn message o
1 = Plays message (1) time
2 = Plays message (2) times (default)
3 = Plays message until receiving party presses * on their phone
Step 4. To Program Auto Disconnect Time (Default is 5 minutes, lowest interval is 1 minute)
a. Press 8, Enter, (3 digit number in minutes)
Ex: 2 minutes = 002
Step 5. To Exit Program Mode
a. Press Stop for 3 seconds
Testing
Did you hear a dial tone?
Did red LED become a solid light when you pushed the button?
Did red LED ash and someone started talking to you?
Could you hear the other party clearly? (If no, see “Adjust Speaker” on page 6)
Could the other party hear you clearly? (If no, see “Adjust Microphone” on page 6)
If you have answered YES to all questions, you have successfully installed and tested
the phone. If you answer NO to any question, proceed to the Troubleshooting Section.
Push the emergency button to activate the VoIP Phone:
YES NO
To Next Page
Loading...
Need help?
General