Page 4
Remote Programming:
Step 1. To Begin Program Mode
A. Call into phone by dialing the number of the phone
B. After rst simulated ring, Press #, # (Wait for 4 tones)
C. Key in security code (Default is 1111) (Wait for conrmation tones)
Step 2. To Program Emergency Numbers
A. Press 1, *, (Phone number), *, # (Wait for conrmation tones)
Note: Emergency numbers (2-5) repeat step 2A pressing (2-5) as needed
Step 3. To Program Location Message
A. To turn on message press 1, 3, *, 2 (Wait for conrmation tones)
B. Press 6, *, (Speak message) #, *, # (Wait for conrmation tones)
i. To replay message Press 6, # (Wait for conrmation tones)
C. For NO message Press 1, 3, *, 0 (Wait for conrmation tones)
Step 4. To Program Auto Disconnect Time (Default is 5 minutes, lowest interval is 1 minute)
A. Press 8, *, (3 digit number in minutes)
Ex: 2 minutes = 002
Step 5. To Exit Program Mode
A. Press *, #, 0 (You will hear a beep, beep) *, # (You will hear a buzz)
Testing
Did you hear a dial tone?
Did red LED become a solid light when you pushed the button?
Did red LED ash and someone started talking to you?
Could you hear the other party clearly? (If no, see “Adjust Speaker” on page 5)
Could the other party hear you clearly? (If no, see “Adjust Microphone” on page 5)
If you have answered YES to all questions, you have successfully installed and tested
the phone. If you answer NO to any question, proceed to the Troubleshooting Section.
Push the emergency button to activate the VoIP Phone:
YES NO
To Next Page
Loading...
Need help?
General