33
BEFORE YOU BEGIN
Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents that may have occurred during shipping. Because
your scooter was partially assembled and packed at the factory, there should not be any problems, even if the box
has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 15 minutes for assembly, not including initial charge time.
Allow up to 6 hours for charge (see page 5 for charging information).
WARNING:
DO NOT USE NON-RAZOR PARTS
WITH YOUR RAZOR ELECTRIC
SCOOTER. Razor scooters have
been built to certain Razor design
specifications. The original
equipment supplied at the time
of sale was selected on the basis
of its compatibility with the
frame and all other parts. Certain
aftermarket components may not
be compatible. Use of non-Razor
parts will void the warranty.
Note: If using the factory set
(default) kick-to-start option,
the electric scooter must
be moving at least 3 mph
(5 km/h) while applying
throttle to engage motor.
Product ID Locations:
(See locations to the left)
1. Side of Deck
2. Charger
3. UPC Side of Box (Not Shown)
Box Contents:
• C45
• Charger
• Owner’s Manual
• Tools and Parts
Required Tools and Parts
Throttle
LED Headlight
Hand Bell
Front Fender
Kickstand
LED Tail/
Brake Light
Handle Hook
1.
Folding Latch Button
Folding Latch
Brake Lever
Steer Tube
ON/OFF Switch
Headlight ON/OFF Switch
LED Battery Indicator
2.5 mm Allen Wrench
(Included)
Four (4) Screws and
Washers (Included)
4 mm Allen Wrench
(Included)
2.
Handle Latch
Charger
(Note: Charger design may
vary from one shown)
To Next Page
Loading...
Need help?
General