3
HEADLINE
3
BEFORE YOU BEGIN
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR RAZOR BALANCE BIKE. Razor
Balance Bikes have been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on the
basis of its compatibility with the
frame and all other parts. Certain
aftermarket products may not be
compatible and will void
the warranty.
Product ID Locations:
(See locations to the left)
1. Frame (underneath unit)
2. Charger
3. Box - side of UPC (not shown)
Required Tools
5 mm Allen Wrench
(included)
Phillips/Flathead Screwdriver
(included)
Grips (Right/Left)
Throttle
Handlebar
Seat
Rear Tire
Parent-Controlled HIGH/LOW
Speed Switch
Charger Port
ON/OFF Switch
Foot Rests (Right/Left)
Fork
1.
Front Tire
Seat Post Clamp
Adult assembly required. Remove contents from box. Inspect the contents for scratches in the paint and/or dents
that may have occurred during shipping. Because this product was partially assembled and packed at the factory,
there should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult or someone with experience in bicycle mechanics.
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge (see page 6 for charging information).
Freewheeling/
Electric Assist
Mode Switch
2.
Plastic Bag Contents:
• Tools
• Owner’s Manual
Charger
Note: Charger design may
vary from one shown
To Next Page
Loading...
Need help?
General
