Razor E Prime III User Manual

HEADLINE
3
BEFORE YOU BEGIN
3
Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents that may have occurred during shipping. Because your
scooter was partially assembled and packed at the factory, there should not be any problems, even if the box has a
few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 5 minutes for assembly, not including initial charge time.
Allow up to 8 hours for charge (see page 7 for charging information).
Charger
(Note: Charger design may
vary from one shown)
2.
Throttle
LED Headlight
Electronic Brake
ON/OFF Button & LED Battery Indicator
Anti-Rattle Folding Mechanism
Collar Clamp
Pneumatic Tire
Reflector Decals
Power Cutoff Fender Brake
LED Tail/Brake Light
1. Product ID
Kickstand
Charger Port
Hub Motor
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
ELECTRIC SCOOTER. Razor scooters
have been built to certain Razor
design specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may not be
compatible and will void
the warranty.
Product ID Locations:
(See locations to the left)
1. Side of Deck
2. Charger
3. UPC Side of Box (Not Shown)
Note: Electric scooter must
be moving at least 3 mph (5
km/h) while applying throttle to
engage motor.
Box Contents:
• E Prime III
• Charger
• Owner’s Manual
• Allen Wrench
Required Tool
5 mm
Allen Wrench

Razor E Prime III Specifications

General

Brand	Razor
Model	E Prime III
Category	Scooter
Language	English