Note: As an additional safety feature, the scooter is designed to cut power to the motor when the
hand brake is applied.
Note: Motor will re-engage, (without having to kick start), if brake is released and throttle is applied
before scooter has slowed down to under 3 mph (5 km/h).
REPAIR AND MAINTENANCE
Turn power switch “OFF” before beginning repair or maintenance:
Read the instructions
Remove charger plug
Turn the power switch off
Secure the unit under repair
Exercise caution around exposed parts
Contact Razor customer service if unsure about any repair or maintenance
Adjusting the Brake
Tool Required: 10 mm Wrench
1 To adjust brake cable play, thread the brake lever adjuster in or out 1/4 to 1/2 turn until the desired
brake adjustment is attained. Most adjustments are complete at this step. If brake still needs further
adjustment, proceed to step 2.
2 If brake is too tight or has too much slack, use a 10 mm wrench to loosen the brake cable and adjust
accordingly.
To Next Page
Loading...
Need help?
General
