Razor FLASHBACK Owner's Manual

4
A
A
B
B
A
A
B
B
A
B
A
A
B
B
A
ASSEMBLY AND SET-UP
Attaching the Rear Wheel
Required Tools: 10 mm wrench and Two (2) 16 mm Wrenches (included)
2 Tighten the axle nuts using
two (2) 16 mm wrenches.
3 Press both sides of the brake
clamp inward until it is close to the
wheel hub. Keep both sides of the
clamp motionless while pulling the
brake cable back. Tighten the nut
with a 10 mm wrench.
1 Insert the wheel into the rear fork and insert the tab on the washers (A)
into the holes (B) on the rear fork. Safety washers should be on the outside
of the fork facing the tire.
WARNING: Failure to
properly install the rear wheel may
cause the rider to lose control and
fall. If you are having difficulty
understanding these instructions,
please contact Razor Customer
Service for assistance.
Attaching the Front Wheel
Required Tools: 10 mm wrench and Two (2) 16 mm Wrenches (included)
2 Tighten the axle nuts using
two (2) 16 mm wrenches.
3 Press both sides of the brake
clamp inward until it is close to the
wheel hub. Keep both sides of the
clamp motionless while pulling the
brake cable down. Tighten the nut
with a 10 mm wrench.
1 Insert the wheel into the front fork and insert the tab on the washers (A)
into the holes (B) on the front fork. Safety washers should be on the outside
of the fork facing the tire.
WARNING: Failure to
properly install the front wheel
may cause the rider to lose control
and fall. If you are having difficulty
understanding these instructions,
please contact Razor Customer
Service for assistance.

Razor FLASHBACK Specifications

General

Brand	Razor
Model	FLASHBACK
Category	Scooter
Language	English