12
Figure 8c.
6E. Assemble the brake cable. The brake lever is preinstalled on the
handlebars and the brake cable adjusting barrel may be either on the
cable or threaded into the lever.
Installing the cable requires placing the barrel (or ball) end of the cable
wire into the socket on the lever and “threading” the wire through the
slots in the adjusting barrel and jam nut as shown in the sequence 9a,
9b and 9c.
Figure 9a. Figure 9b. Figure 9c.
To properly accomplish this procedure, you may have to disconnect the
brake quick release in order to get enough slack in the wire to connect
the cable. This is shown in figures 10a and 10b.
To Next Page
Loading...
Need help?
General
