Turning On and Off
Connect the AC cord to power the LCD TV. At this time the TV will enter standby mode and power indicator will turn red.
Use Power button (_) on the top panel of TV or on the remote control to turn on the TV. After switching off the TV for 5 seconds,
you can turn on TV again.
Choosing TV Channel
Tuning To Analog Channels
An analog channel has a channel number beginning with "A". Input the digital number with numeric buttons directly and press
ENTER button to confirm.
For example, to watch analog channel "A51 ", press "5", "1 ", "ENTER" on remote control in sequence.
Note: Although there is no analog 7q/signal available in America, we reserve ATe! functions for some expansible use.
Tuning To Digital Channels
A digital channel has a channel number beginning with "D". Input the main digital number with numeric buttons directly, then press
,, m" button on remote control, and input the sub number at last.
For example, to watch analog channel "D31-1 ", press "3", "1 ", ..... , "1 ", "ENTER" on remote control in sequence.
Changing Channels Directly
You can use CH/', button to increase channel number and CHv to decrease channel number. When no OSD (On Screen Display)
is used, the up/down arrows can also work as CH/',/CHv buttons.
Selecting Input Source
Press INPUT button on remote control to display Source Select list.
Use up/down arrows to highlight the source you need and press ENTER to confirm.
!!
Adjusting TV Stand Angle
The TV cabinet can manually adjust to left or right for 30 degrees from the center.
You can adjust the angle for the best viewing effect and comfort.
21
To Next Page
Loading...
Need help?
General