63
Playback
Caution: If the load detector is still
extending from the side of the cassette
adapter after you have attempted to load
the cassette, loading is not complete. Try
to load the cassette again. Attempting to
insert the cassette adapter into a VCR
with the load detector extending may
cause damage to the adapter and/or VCR.
4. Gently close the cassette compartment
lid until it locks into place. Make sure
the cassette reel area under the adapter
is free to turn while the cassette is
loading.
Note: You should hear a whirring sound
while the tape loads. The adapter’s load
detector will automatically retract into the
adapter.
Remove Cassette from Cassette Adapter
1. Slide the adapter’s EJECT switch to
the right. The load detector extends
from the side and the whirring sound
indicates the tape is being released
before the adapter’s cassette
compartment lid opens.
2. Use the access hole on the bottom of
the adapter to push the cassette up and
remove it from the adapter.
3. Gently close the adapter’s cassette
compartment lid.
Load Detector
Access Hole
Reels
Caution: Do not touch the
reels during loading and
unloading. It could cause
injury or damage the cassette
adapter or tape.
Use the Cassette Adapter (continued)
To Next Page
Loading...
Need help?
General
