Graphics contained within this publication are for representation only.
16
Chapter 1: Connections and Setup
The audio input jacks on the audio receiver you use to connect to the DVD recorder will determine which source or input you need to select on
the A/V receiver when you want to watch TV or play a disc.
3b. If you have a Dolby Digital or DTS receiver, connect a digital audio coaxial cable to the DIGITAL AUDIO OUT jack on the DVD recorder and
the Digital Audio Input jack on the receiver (cable not supplied with DVD recorder). You must also adjust the Audio setting (go to page 34 for
information).
Notes:
If your TV is capable of progressive scan, connect the DVD recorder to the TV using the COMPONENT VIDEO OUT jacks, and press the
HDMI button on the remote to toggle between progressive scan and interlace. Please note that the component video output mode
will remain at 480p even though the HDMI video output mode is 480p/720p/1080i, which is displayed on the front of the unit.
4.
Plug the power cord into an AC outlet.
Go to page 17
To Next Page
Loading...
Need help?
General
