Graphics contained within this publication are for representation only.
7
Chapter 1: Connections and Setup
Front of the DVD Recorder
STANDBY/ON –
Turns the DVD recorder on and off.
CH- (channel down) –
Goes to the previous channel in the channel list when you’re watching TV.
CH+ (channel up) –
Goes to the next channel in the channel list when you’re watching TV.
OPEN/CLOSE –
Opens and closes the disc tray.
STOP –
Stops playback and/or recording.
PLAY/PAUSE –
Starts playback of a disc. Pauses recording or playback.
INPUT –
Just like a TV has Video Input Channels (page 20), the DVD recorder has one Video Input Channel for each set of INPUT jacks. The Video
Input Channel is the “channel” to which you tune the DVD recorder so you can see the picture and hear the sound that’s coming from the component
that is connected to the DVD recorder’s INPUT jacks. For example, if you connected your camcorder to the Audio and Video Input jacks on the front of
the DVD recorder, you would press the INPUT button until AV 2 appears.
DVD RECORD –
Records content to a DVD disc.
Front Input Jacks:
DV IN – This jack is provided when you’re connecting a DV camcorder through a IEEE 1394 Firewire connection. The DV connection can also control the DV playback
using the DVD recorder’s remote.
INPUT 2: Audio/Video jacks – These Input jacks are provided for convenience when you’re connecting a temporary component, such as a camcorder.
S-VIDEO – If a component you’re connecting, such as a camcorder, has an S-Video Output jack connect it to this jack for picture quality that is better than regular video
(yellow). Remember, you still have to connect audio cables to hear sound.
To Next Page
Loading...
Need help?
General
