Step 3: Program the supplied remote control
You can control TV sets of all major brands after programming the Converter Box remote control with the PGM key. RCA TV sets
can be controlled directly without programming. Refer to the steps below and the separate Program Code leafl et to guide you
through the programming.
1. Refer to the separate Program Code leafl et. Look for the brand of your TV set and a 3-digit program code next to it. There
may be more than one program code available. Choose any one of them.
• If your TV set is not on the list, skip the rest of this section and go to “Step 4: Initial setup of the converter box”.
2. Press PGM on the remote control. The signal indicator on it remains lit.
3. Enter the 3-digit program code with the number keys. Press OK for confi rmation. The signal indicator will be off when the
program is done.
4. Press the volume keys on this remote control to check if they can adjust the volume of your TV set.
• If you fail to control your TV set, repeat steps 2 to 4 to program again. Try another program code if there is more than one
for your TV brand.
• If the signal indicator remains lit after blinking four times, you may have entered the wrong code. Repeat steps 3 to 4 to
program again. Make sure you have correctly entered the code.
• Refer to User Manual for controlling some features of your TV set with this remote control.
signal indicator
Program codes/Códigos de programa
Admiral 002, 128, 183, 189
Advent 191, 258, 260, 275
Adventura 129
Aiko 014, 182
Aiwa 289, 290
To Next Page
Loading...
Need help?
General
