Setting up
Program codes/C6digos de programa
• You can still use your TV remote control
to turn on your TV set, select input
source and control the volume.
3. Press
INPUT
up to four
times (or use the TV
remote control) to select
the channel on your TV set
to view images from the
converter box.
• The following screen will appear on your
TV when the correct channel is chosen.
Step 4: Initial setup of the
Converter Box
1. Press BOX
C>
on the remote
control to turn on the
Converter Box.
• If you cannot see the above screen on
your TV set, check that:
1) if the converter box has been turned
on,
2) if you have programmed the remote
control so that the TV input channel can
be selected correctly,
3) if you have correctly connected the TV
set with the Converter Box.
4. Press
1
(for English), 2 (for
Spanish) or 3 (for French) to
select the menu language.
5. Press
1
to start automatic channel search.
Franyais - 3 Letextedesmenuseslafficl1een
fran~is
Espanal • 2
EI
texto
del menu
se
exhibe en
espallol.
Language
Choose the language to be used in the menu system
IBiII
Menu texl is r;Itsplayed in English
2. Press TV
C>
(or use the TV
remote control) to turn on
the TV set.
signal
indicator
Admiral 002, 128, 183, 189
Advent 191, 258, 260, 275
• If your TV set is not on the list, skip the
rest of Step 3 and go to "Step 4: Initial
setup of the Converter Box".
2. Press
PGM
on the remote control. The
signal indicator on it remains lit.
Step 3: Program the supplied
remote control
You can control TV sets of all major brands
after programming the Converter Box
remote control with the PGM key. RCA
TV sets can be controlled directly without
programming. Refer to the steps below and
the separate Program Code leaflet to guide
you through the programming.
1. Refer to the separate Program Code
leaflet. Look for the brand of your TV
set and a 3-digit program code next to
it. There may be more than one program
code available. Choose anyone of them.
3. Enter the 3-digit program code with the
number keys. Press
OK
for confirmation.
The signal indicator will be off when the
program is done.
4. Press the volume keys on this
remote control to check if
they can adjust the volume
of your TV set.
~Slartchannelsearch.
• If you fail to control your TV set, repeat
steps 2 to 4 to program again. Try
another program code if there is more
than one for your TV brand.
• If the
signal
indicator remains lit after
blinking four times, you may have
entered the wrong code. Repeat steps 3
to 4 to program again. Make sure you
have correctly entered the code.
Channel Scan
Channel scan wmsearch for channels available in your
3rea.Youmayhavetore-adjusttheanlennaanr;!
retry the scan to capture all available channels
(
• To improve TV signal reception, an
optional Smart Antenna which is
compatible for connection with the
Converter Box is recommended.
6
DTA800-B
To Next Page
Loading...
Need help?
General
