PC Connection
This is an example of a connection usingthe PC INPUTVIDEOjack. Go to page 12 for specific instructions.
Don't forget:
If necessar_ connect
antenna or cable to get
a picture. Go to page 8
for instructions.
Viewing the Picture from the Connected Component
1. Plug in the TV (see page 14 for details) and the component, such as a DVD player or a VCR.
2. Turn on the TV and the component you want to view.
3. Press the INPUT button on the remote control to display the signal source. Press the up or down arrow
to select VlD 2 (if connected to the VIDEO INPUT 2 jacks), CMPT (if connected to the CMPT jacks)
or HDMI 1 (if connected to the HDMI/DVl INPUT 1 jack). Press OK to confirm your selection. To return
to viewing TV channels, use the number buttons to enter the channel you wish to view.
Note: If the picture from the DVD player appears black and white and your component ls connected to the
WDEO INPUT, you may be tuned to the wrong input. Make sure you press INPUT and use the up or down
arrow until you see WD 1, CMPT or HDMI 1 displayed at the top left of the 7l/screen. Press OK to confirm.
Note: When you have connected all additional components to your 7l/, go to page 15 for initial setL4oinstructions.
Viewing a PC
1. Plug in the TV and the computer.
2. Turn on the TV and the computer.
3. Press the INPUT button on the remote control to display the signal source. Press the up or down arrow
to select PC. Press OK to confirm. To go back to viewing TV channels, use the number buttons to
enter the channel you wish to view.
Note: When you have connected all additional components to your 7l/, go to page 15 for initial Setup Instructions.
Connections and Setup ::; 13
To Next Page
Loading...
Need help?
General
