To Next Page

To Previous Page

English

NOTES:

• If the extension unit's indicator light does not turn green in step 2,

press its PROGRAM button again.

• Do not press the PROGRAM button on the extension unit while

its indicator light is flashing. Wait until its indicator light is not

flashing.

• If the base unit is not in program mode when you press the

extension unit's PROGRAM button, the extension unit's indicator

light will flash red for about ten seconds and then turn solid red.

If you still want to program the extension unit, start from step 1

above. If you do not want to program the extension unit, unplug

the extension unit, and plug it back in to restore a solid green

indicator light.

4.Whenyouhavefinishedprogrammingalltheextensionunits,press

thePROGRAMbuttonontherightsideofthebaseunit.Thistakes

thebaseunitoutofprogrammode;thebase'sindicatorlightturns

green.

 Makesuretheindicatorlightsontheextensionunitsarealsosolid

green.

NOTE: If you forget to press the button on the base unit after you've

finished programming, the base unit will remain in program mode

for five minutes and then return to normal operating mode (its

indicator light returns to solid green).

RCA RC940 User Manual

Questions and Answers: