To Next Page

To Previous Page

Note: The indicator lights on the base and extension units blink green

when the handset connected to the extension unit is taken off its hook.

3.Pickupthehandsetandlistenforadialtone.Ifyouhearone,you've

successfullysetupthebaseandextensionunits.Ifyoudonotheara

dialtone,seetheTroubleshootingsectioninthismanualforpossible

solutions.

Programming Additional Extension Units

Followthesestepstoaddextensionunitstoyourcurrentsetup.

Note: If your first extension unit's indicator light remains red, follow

these steps to get the extension and base units to recognize each other.

1.PressthePROGRAMbuttonontheright

side of the base unit. The indicator on

the front of the base unit begins to flash

orange. The base unit is now in program

mode,whichallowsnewlyaddedextension

units to get the current link code.

NOTES:

• If the base unit's indicator light turns solid

red before it begins to flash orange, you

need to press the PROGRAM button on

all extension units while the base is in

program mode.

• Make sure neither the base nor extension

unit is plugged into a surge protector, plug

strip, or extension cord.

2.PressthePROGRAMbuttonontheright

sideoftheaddedextensionunit(or,

ifyou'renotaddinganextension,the

unitwithasolidredindicatorlight).The

indicatorlightontheextensionunitflashes

red,thenturnssolidgreen.

 Ifyouareaddingmorethanoneextension

unit,pressthePROGRAMbuttononeach

addedextensionunit.

RCA RC940 User Manual

Questions and Answers: