RCA RCU400KTP User Manual

Custom TV (Systemlink Exclusive)
The CUSTOM button allows you to store 10 of your favorite TV channels in
memory. You can access these channels using the remote's number buttons.
Follow the steps below to program channels to each of the number buttons.
Programming the Custom Button
1. Press and hold CUSTOM.
2. Press the number (0-9) you want to use to
bring up the custom channel. For example,
if you want to program channel 12 to
the number 1 button, press l.
3. Enter the channel number as you would
normally. Up to three buttons may be
pressed, including the ENTER button.
4. Release CUSTOM. The Custom button will
flash once if programming was successful.
If it does not flash, it was not programmed.
Try again.
5. Repeat steps 1-4 for each additional channel.
Using the CUSTOM feature
1 . Press and release CUSTOM.
2. Press a number button to bring up the
Custom channel programmed. Custom will
flash if the button has been previously
programmed. There will be a slight delay
as channels change, so be sure to hold
the number button down until the
channel changes.
3. The CHANNEL UP or DOWN keys can now
be used to cycle through all programmed
number buttons while in the Custom mode.
To Turn off the Custom Feature.
6
Press any device button (TV, VCR, CABLE,
AUX) to exit the remote from the Custom
mode and place it in normal operating mode.
PRESS
& HOLD
-
•
CUSTOM
•
10
2
0
3
0
40
5
0
6
0
70
8
0
9
0
EiRoo
RELEASE -t--
CUSTOM
CUSTOM
10
2
0
3
0
40
5
0
6
0
70
8
0
9
0
°0
A
CHAN
..
AUX CABLE VCR TV
000 0

RCA RCU400KTP Specifications

General

Brand	RCA
Model	RCU400KTP
Category	Remote Control
Language	English