3
Place Batteries in the remote
1. Remove the battery compartment cover.
2. Place four AAA batteries as shown,
matching the + and – end of each battery as
indicated in the battery compartment.
3. Replace the cover.
Determine if your remote needs programming
Some RCA, GE and ProScan devices may already be pre-programmed.
1. Press the button of the device you want to
control (for example TV).
2. If the device turns on, press another button
to confirm (for example CHANNEL UP).
3. If the device you selected (TV) responds,
you will not need to program the remote.
If the device you selected (TV) does
not respond, you will need to program
the remote. (See pages 4-5 for
programming instructions).
4. Repeat steps 1-3 for other devices.
Setting Up Your Universal Remote
To Next Page
Loading...
Need help?
General
