4
Operating the Clock
Setting Clock Time
Your digital clock operates on a 12-hour
standard mechanism. A green indicator
will be shown below to AM when the unit
is reading AM time.
1. Slide the function selector to CLOCK.
2. Press REV or FWD to set the clock time.
When you press and hold REV or FWD,
the time decrements or increments will
follow by a fast rate. No adjustment
can be made when mode is selected.
Setting the Wake Time
This clock radio has two separate alarms.
You need to set each of them individually.
1. Slide the function selector to WAKE 1
or WAKE 2.
2. Press REV or FWD to set the wake time.
The time decrements or increments will
follow by a fast rate when you press and
hold REV or FWD.
3. Wake time is set. A green indicator is
up on the left-hand side when WAKE 1
is activated while on the right-hand side
when WAKE 2 is activated.
4. To disable WAKE function, press and
hold WAKE 1 or WAKE 2 button until
the indicator disappears.
Cancel Wake Function
1. Press CANCEL
2. Press WAKE1 or WAKE2 button to
disable the wake function.
Note: The unit equips with GRAD-U-
WAKE feature, the alarm tone vol-
ume will increase gradually to its
maximum in about 30 to 45 seconds.
Auto Dimmer
Slide the AUTO DIMMER switch at the back
of the unit to ON. The brightness of the
LED display will vary automatically
according to the environment.
Slide to OFF, the display will maintain at
the brightest level.
EN
CLOCK
WAKE 1 WAKE 2
WAKE 1
WAKE 2
NAP
SLEEP
PRESS HOLD TO CANCEL
REV
FWD
ON/OFF
CANCEL
SNOOZE
V O I C E
ON
OFF
AUTO DIMMER
RP3715 EN-US 6/21/01, 12:05 PM5
To Next Page
Loading...
Need help?
General
