EN
16
Alarm Settings
Nap Mode
For catnaps up to 2 hours without
disturbing the regular alarm settings, the
NAP function wakes you up after a short
period of time. Simply:
1. Press NAP, the NAP indicator will flash.
While the NAP indicator is flashing,
press
or to adjust nap time. The
time range is from 10 minutes to 2 hours
at 10 minutes interval (default is 20
minutes).
2. Wait 3 seconds or press NAP again to
confirm, the NAP indicator will show
on the display.
3. Press NAP once to show time left, after
3 seconds, the display will return to
clock time.
Stopping the Nap Alarm
When the NAP alarm sounds, you can
press OFF to stop it.
Cancelling the Nap Alarm
Press and hold NAP for 5 seconds to
cancel the nap setting.
Snooze
This operation allows extra sleep time
after the alarm is on. The alarm will be
off by pressing SNOOZE until the snooze
period is over. Snooze function can be
used repeatedly up to 2 hours. After this,
the alarm will turn off until the next
alarm conditions are met. Set the
“quiet” period as follow:
1. While pressing SNOOZE, press
or
to set the “quiet” period (the default
time is 9 minutes) from 1 minute to 30
minutes. Release SNOOZE, then the
“quiet” period is set.
2. The “quiet” period will remain the same
until you change it again.
Brightness
1. Rotate the TURNING KNOB to the
BRIGHTNESS position
2. Press
or to set the brightness level.
Tip:Tip:
Tip:Tip:
Tip:
Only alarm tone can be selected
in NAP mode.
To Next Page
Loading...
Need help?
General
