12
EN
Radio
Selecting Tuner Band
1. Press SOURCE repeatedly to enter Tuner mode.
2. Press BAND to select between FM or AM
Radio band.
Tuning to a Station
Press SKIP BACKWARD or SKIP
FORWARD to select frequencies.
Using Presets
The tuner can be in either TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
• Press STOP to toggle TUNE and PRESET
mode.
• Press SKIP BACKWARD or SKIP
FORWARD on the
main system or FOLDER/PRESET or to
access the previous or next preset station.
The display first shows the preset program
number and after a few seconds, the frequency
will be displayed.
(FMPR:01 is FM preset 1)
Auto Preset Programming
(FM only)
Press and hold the BAND button for 2 seconds to
scan stations in FM band. The stations will then
be stored as preset channels. A maximum of 32
stations can be stored. Beware of your preset
channels being erased accidentally because the
scanning and storing process is automatic upon
pressing the button. You can stop the automatic
scan by pressing any button, but the erased
stations cannot be recovered.
Manually Setting Presets
1. Press the STOP button to enter TUNE
mode.
2. Press SKIP BACKWARD or SKIP
FORWARD to access the desired
frequency.
3. Press the PROG/SET button once.
4. The most recently accessed program location
will be displayed.
5. If a different program location is preferred,
press SKIP BACKWARD or SKIP
FORWARD on the main unit or
FOLDER/PRESET or to move to the
desired preset number (1-32).
6. Press PROG/SET to store the selected
frequency at that preset.
Suppressing Stereo Signal
Press FM ST to toggle between FM mono and
stereo mode. (Remote Only) “STEREO” is
displayed in stereo mode.
Tips:
Your audio system has 32 preset stations.
To Next Page
Loading...
Need help?
General
